Connect a primary computer and one or more secondary computers so they all use the same AuctionFlex data. Start here, then set up the primary computer and each secondary computer. This applies to AuctionFlex Legacy v9.x and v10.
Note: If your computers are already set up and won’t connect, see Networking Troubleshooting for Auction Day.
Before you start
Two or more computers or laptops with Windows 10 or newer. Chromebooks and tablets with a mobile operating system aren’t supported.
One wired router. Wi-Fi isn’t required.
One Ethernet cable (Cat 6 or higher) per computer, long enough to reach the router.
AuctionFlex installed on the primary computer.
Important: Connect every computer to the router with an Ethernet cable, not Wi-Fi. A Wi-Fi connection can corrupt or lose your auction data.
Note: Antivirus software can block AuctionFlex from communicating between computers. If you have connection problems, ask your IT professional to add an exception for AuctionFlex.
How your setup works
The primary computer stores all of your AuctionFlex data, images and reports.
A secondary computer, also called a workstation, connects to the primary computer to use that data.
You share the AuctionFlex folder on the primary computer. Each secondary computer then maps that folder as a network drive, which gives it a drive letter such as X:. Secondary computers must stay connected to the primary computer through this mapped drive.
Turn on sharing settings
Complete these steps on the primary computer first. Then repeat them on each secondary computer.
Select the Start button.
Type Control Panel, then press Enter.
Go to Network and Internet > Network and Sharing Center.
On the left, select Change advanced sharing settings. The page shows three sections: Private, Public and All Networks.
In the Private and Public sections, turn on every option.
In the All Networks section, turn on every option except Password protected sharing. Turn that option off.
Important: These settings make shared folders easier to reach from other devices on the same network. Use them only on a network you control, such as a router used only for your auction computers.
Set your network type to Private
Windows can label a new network as Public, and AuctionFlex computers need a Private network type. Do this on the primary computer and on every secondary computer.
On Windows 11
Go to Start > Settings.
Select Network & internet.
Select Ethernet.
Select your active connection.
Under Network profile type, select Private.
On Windows 10
Go to Start > Settings.
Select Network & Internet.
In the left pane, select Ethernet, then select the name of your connected network.
Under Network profile, switch from Public to Private.
Note: If a computer is set to Public, it may not appear in the Network list on the other computers.
What to do next
Set up the primary computer. See Set Up the Primary Computer on a Network.
Set up each secondary computer. See Set Up a Secondary Computer on a Network.
FAQ
Can I use Wi-Fi for a secondary computer?
No. A Wi-Fi connection can corrupt or lose auction data. Connect every computer to the router with an Ethernet cable.
Related articles
Set Up the Primary Computer on a Network: share the AuctionFlex folder and check SMB2
Set Up a Secondary Computer on a Network: map the drive, install AuctionFlex and set the data path
Networking Troubleshooting for Auction Day: fix computers that can’t see each other
AuctionFlex Hardware Guide: review hardware options, including RF modems for venues without a network



